Power & Pantry

How Long Will a Power Station Run a Heated Blanket?

A typical heated blanket draws about 100 W while its heating element is on. Divide a power station's usable capacity by that draw and the answer is friendly: a 1 kWh station runs that blanket for about 8.5 hours at full draw, roughly one full night, and a 2 kWh station for about 17 hours, roughly two nights. A smaller 60 W blanket does better; a dual-control blanket with both sides on does worse. The full tables are below. One warning from the blanket makers themselves comes first, because it decides whether the tables apply to your blanket at all.

Affiliate disclosure: Power & Pantry is reader-supported, and some links on this site are affiliate links that may earn us a commission at no extra cost to you. This article links to our own calculator and comparison pages. See the About page for how we work.

The short answer: usable capacity is the station's rated watt-hours × 0.85, because inverter and conversion losses take their cut before any power reaches the blanket. Runtime in hours is usable capacity ÷ the blanket's watts. A night in these tables is 8 hours. Every figure below comes from that one formula, printed in full further down, and from blanket wattages published by the US Department of Energy and by blanket manufacturers.

Read this first: the warning in the blanket manual

Most pages that answer this question with a runtime table never mention what the largest heated-bedding manuals actually say. Sunbeam's heated bedding user manual (P.N. 174822, the manual Sunbeam publishes for its blankets, mattress pads, and throws) instructs, in its list of important instructions: be sure the product is used only on an AC supply circuit of 110-120 volts, 60 Hz; do not use with an extension cord; do not use with generators, power converters, or inverters. The setup section repeats it as a caution: do not use with generator power.

A portable power station makes its AC power with an inverter. That is the device class the manual names. Sunbeam's connected-bedding manual carries the same instruction in the same words, so this is not one model's quirk; it is the brand's standing instruction across its heated bedding line.

What we cannot tell you is why. The manual states the rule and gives no reason, and we will not invent one. A power station maker's claim about its output waveform describes the station; it does not amend another manufacturer's safety instruction.

What follows from it, practically:

How many watts is a heated blanket?

The US Department of Energy's Energy Saver appliance list, republished by Virginia Cooperative Extension, gives nameplate wattages for an electric blanket of 60 W for a single and 100 W for a double. Manufacturers' own documents land in the same place: Sunbeam's manual for its queen MicroPlush blanket rates that blanket at 120 V, 60 Hz, 100 W, and dual-control queen and king models carry two heating zones, with manufacturer specifications rating the sides separately (Sunbeam's heated comforter specifications, for example, rate the full/queen at 140 W per side). Both zones on at once is the top of the range.

Two things to hold onto. First, the wattage on a label is a maximum: the Energy Department's guidance states that the listed wattage is the maximum power drawn, and that actual consumption depends on the setting in use. Second, your blanket's own label beats any table, including this one. Our generator wattage calculator uses 100 W and 8 hours as its heated blanket preset, and the tables below use three draws that cover the published range:

The runtime tables

These tables assume the blanket draws its full rated watts for every minute it runs. That is the conservative case, and the next section explains why real nights usually do better. Read the tables as clock time from a full charge, with nothing else plugged into the station.

Small blanket: about 60 W

Station size (rated)Usable Wh (× 0.85)Blanket runtime (hours)Blanket runtime (nights of 8 h)
300 Wh2554.30.53
500 Wh4257.10.89
1 kWh (1,000 Wh)85014.21.77
2 kWh (2,000 Wh)1,70028.33.54
3.6 kWh (3,600 Wh)3,06051.06.38

Typical blanket: about 100 W

Station size (rated)Usable Wh (× 0.85)Blanket runtime (hours)Blanket runtime (nights of 8 h)
300 Wh2552.60.32
500 Wh4254.30.53
1 kWh (1,000 Wh)8508.51.06
2 kWh (2,000 Wh)1,70017.02.13
3.6 kWh (3,600 Wh)3,06030.63.83

Dual-control blanket, both sides on: about 200 W

Station size (rated)Usable Wh (× 0.85)Blanket runtime (hours)Blanket runtime (nights of 8 h)
300 Wh2551.30.16
500 Wh4252.10.27
1 kWh (1,000 Wh)8504.30.53
2 kWh (2,000 Wh)1,7008.51.06
3.6 kWh (3,600 Wh)3,06015.31.91

One night at full draw costs 480 Wh of battery for the 60 W blanket, 800 Wh for the 100 W blanket, and 1,600 Wh for the dual-control blanket with both sides on. Those three numbers are the ones to carry into any plan that also includes a fridge.

Placeholder: matched offers

When this site's affiliate programs are approved, this block will show the stations in the size class your own numbers call for, with dated prices and a one-line "why this size" tied to your appliance list. Until then, run your list through the generator wattage calculator first, and see the sized-by-need station comparison for the models behind each size class. The tier matters more than the brand.

No affiliate links are live on this page yet, and nothing here is a product endorsement.

Why real nights usually beat the table

The element cycles. A heated blanket is thermostatically controlled. Sunbeam describes its heating technology as sensing shifts in room and body temperature and adjusting its output to hold the setting you chose. On a low or medium setting, and once the bed is warm, the element is off for part of every hour, and the average draw falls below the nameplate figure. The tables ignore that on purpose: they are the floor, not the forecast.

The planning case. For planning, this site uses a labeled assumption: a blanket holding a moderate setting averages about half its rated draw across a night. At that planning case, every runtime in the tables roughly doubles. The 100 W blanket on a 1 kWh station plans at about 2 nights instead of 1, and one night costs about 400 Wh instead of 800. Treat the half-draw case as an assumption with its name on it, not a measurement: your setting, your room temperature, and your blanket decide where the truth lands between the two cases. Size the station on the full-draw table; let anything better be margin.

The timer ends the draw. Sunbeam's manual sets its blankets and mattress pads to shut off automatically after 10 hours of continuous use, and its throws after 3 hours; some current models let you select a shut-off of up to 12 hours. An 8-hour night fits inside a blanket's 10-hour timer. A throw's 3-hour timer does not cover a night, which is one reason throws and bed blankets are different tools in an outage. When the timer ends, the draw ends with it, so a blanket cannot drain a station past its own shut-off.

The comparison that makes the blanket interesting: a space heater

The same Energy Department list that rates a double blanket at 100 W rates a portable space heater at 750 to 1,500 W. Put the big heater setting on the 1 kWh station from the tables and its 850 usable Wh last about 34 minutes. The 100 W blanket runs 8.5 hours on the same charge. Even the heater's low end, 750 W, empties that station in about 1.1 hours.

That is the whole case for the blanket in one comparison: heating the person instead of the room costs roughly a tenth or less of the battery. It is an energy comparison only. Both devices carry their own manuals and their own safety rules, and the safety note below covers the blanket's.

A worked example: the fridge and the blanket share one battery

  1. The fridge comes first in any outage plan. A typical fridge uses about 1,800 Wh a day, as our refrigerator runtime article works through.
  2. One night of a 100 W blanket at full draw adds 800 Wh. Together: 1,800 + 800 = 2,600 Wh of usable capacity for one day of fridge and one night of blanket.
  3. A 2 kWh station holds 1,700 usable Wh. It cannot cover both, and it does not quite cover the fridge alone for a full day.
  4. The 3.6 kWh class holds 3,060 usable Wh. It covers the pair with about 460 Wh to spare at full draw, and with about 860 Wh to spare if the blanket averages the half-draw planning case (400 Wh for the night).

So on a mid-size station, warmth and the fridge compete for the same watt-hours, and the honest options are a bigger station, solar refilling it during the day, or running each load in stretches. It is better to see that on paper in November than to discover it at 3 a.m. in January.

Run your own numbers

The tables cover the blanket alone. Your outage load is the blanket plus the fridge, lights, the router, and everything else you refuse to give up. Our generator wattage calculator runs the same math for your full list, heated blanket preset included at 100 W and 8 hours, and tells you which station size class your numbers call for. If you are choosing a station as well, the home backup comparison sizes models by the same loads used here.

Questions people actually ask

Will a 500 Wh station run a heated blanket all night?

At full draw, not for a typical blanket: 425 usable Wh runs a 100 W blanket about 4.3 hours. A 60 W blanket gets about 7.1 hours, close to a night but short of it. If the blanket averages the half-draw planning case once the bed is warm, the 100 W blanket plans at about 8.5 hours, which is borderline rather than assured. For a guaranteed full night at full draw, the 1 kWh class is the honest answer.

How long will a 2 kWh station run a heated blanket?

About 17 hours at 100 W full draw, which is 2 nights of 8 hours with an hour to spare. At the half-draw planning case, about 34 hours, or roughly 4 nights.

Can one power station run two heated blankets?

On capacity, two blankets are the 200 W table: a 1 kWh station runs the pair about 4.3 hours at full draw, and a 3.6 kWh class station about 15.3 hours, close to 2 nights. The inverter's watt rating is rarely the limit here, since 200 W is a small load; the battery's size is. Each blanket's own manual still governs that blanket, including the inverter instruction above.

Does a heated mattress pad use the same power?

It is the same class of device, and Sunbeam's manual governs its blankets, mattress pads, and throws in a single document, inverter instruction included. Pad wattages vary by model, and the pad's own label is the figure to use. The formula does not change: usable capacity ÷ the label's watts.

My blanket's manual says no inverters, but my station advertises pure sine wave output. Which one wins?

The blanket's manual. The station maker's waveform claim is a statement about the station's output; it does not rewrite another manufacturer's safety instruction, and the manual gives no exception for any kind of inverter. If a heated blanket is part of your outage plan, shop for the manual as much as the blanket: read the safety instructions of any model you are counting on, while you still have the power to choose a different plan.

What about 12-volt car blankets and DC heated blankets?

They are a different product class, made for vehicle sockets, with their own ratings. We did not verify DC blanket wattages for this page, so they are not in the tables and we will not guess at them. Your station's 12-volt output rating and the blanket's label are the two documents that decide that pairing.

Safety and responsibility. The runtime math never outranks the manuals and the safety record. The Electrical Safety Foundation International (ESFI) reports that heating pads and electric blankets cause almost 500 fires each year, and that almost all of those fires involve electric blankets more than ten years old. ESFI's guidance: replace any worn or old blanket; look for dark, charred, or frayed spots and cracked or frayed cords; never fold an electric blanket while it is in use, because a folded or tucked-in blanket can overheat; do not allow anything on top of a blanket in use, including other blankets or pets; do not plug an electric blanket into an extension cord or power strip; and buy blankets approved by a Nationally Recognized Testing Laboratory such as UL, CSA, or ETL. ESFI also holds that heating appliances should never be left unattended or used while sleeping. Blankets are sold for bed use and carry thermostats and automatic shut-off timers, 10 hours on Sunbeam's current blanket line, and we print ESFI's position alongside that fact because both are part of the record. Sunbeam's manual adds its own restrictions, including that its heated products are not for use with an infant, a child, an incapacitated or immobile person, a diabetic, or anyone insensitive to heat or unable to understand the instructions and operate the controls. Before the season, check your model against the US Consumer Product Safety Commission's recall listings at cpsc.gov. Your blanket's manual governs your blanket; this page governs nothing but the math.
Our data basis: every runtime figure on this page is computed from a published model, not presented as a measurement of any product. Blanket wattages are the US Department of Energy's Energy Saver nameplate figures for electric blankets (60 W single, 100 W double), as republished by Virginia Cooperative Extension, and Sunbeam's manufacturer documentation: its queen MicroPlush manual rates that blanket at 100 W, and its heated bedding user manual (P.N. 174822) carries the inverter and extension cord instructions, the 10-hour blanket and 3-hour throw automatic shut-off, and the use restrictions quoted above. Fire and handling guidance is the Electrical Safety Foundation International's, checked on its site in November 2026. The model is the same one our calculator uses: usable capacity at 85% of rated watt-hours, full-draw tables, and a half-draw planning case that is labeled an assumption wherever it appears. No blanket and no power station was tested by us for this page.